>  Reason:

> Solution:

Return of the material into the inlet of the -
die because its specific weight is too low.

Failing receipt of materials on part of the die
owing to:

• the material is too greasy
• excessive clearance between rolls and line screw feeder
• problems on rolls and/or die
• the thickness of the die is too much

• Increase of the speed of the die
• Finer milling
• Study of methods to avoid the return

• Less steam and/or control of the steam are required
• Add less molasses
• Adjust the rolls
• Check the thickness of the die

>  Reason:

> Solution:

Overload of the mill motor, owing to the
gelling of the product:

• too much steam
• die too thick
• low quality steam
• too humid steam

Product is not conditioned at its best >

Too much clearance between rolls and die >

Pellet are too hard >

Corrosion in the inside of the holes of the die >

Only one part of the drilled die strip is operating >

• Less steam is required
• Replace the die
• Check the steam line
  

• Steam is to be increased
  
• Rolls are to be adjusted.

• Use thinner dies

• Use stainless steel dies

• Clean the rows of the clogged holes.
• Give the right direction to the product by means of the deflectors