La Meccanica srl di Reffo- We produce stainless dies for all kinds of pellet mills:
La Meccanica, Buhler, Matador, VanAarsen, CPM, Paladin, Mabrik etc.

< BACK TO MAIN PAGE
:: ABOUT DIES
:: DIES
    
:: INFOTECH
    > types of steel
    > die life
:: TERMINOLOGY
:: SPECIFICATION
    > characterictics of dies
    > thick dies
    > thin dies
    > correct use of dies

> QUOTATION REQUEST
> CONTACT
> WRITE TO US

:: THE TERMINOLOGY OF DIES

 

 

The inlet of the holes in the die have a countersink, encouraging material into the holes. The countersink can have different shapes:
Usually the countersink is 55 to 60°. The characteristics of the countersink are also important because a countersink that is too deep could give the die a pre-compression effect, risking clogging and blockage especially in the first working hours.